Asante Technologies 1012 - Manual (Page 91)

Page 3-35
Configuration Menu System
❏ Status enables or disables the filtering function for this
range of addresses.
To use the Bridge Filtering Table, do the following:
1
Use the arrow keys to highlight the LO DST address field
and press return .
The current value in the field is displayed in the data entry
bar at the bottom of the window.
2
Enter control-u to clear the entry bar and enter the new
lower range limit for packet destination addresses for this
parameter set.
Press return when the entry is correct.
3
Select the HI DST address field and press return .
4
Enter the new upper range limit for packet destination
addresses for the parameter set.
Press return when the entry is correct.
5
Select the LO SRC Address field and enter a new lower
range limit for packet source addresses.
Press return when the entry is correct.
6
Select the HI SRC Address field and enter a new upper
range limit for packet destination addresses.
Press return when the entry is correct.
7
Select the LO Type field and define the lower range limit
for packet types (protocols).
8
Select the HI Type field and define the upper range limit for
packet types.
9
Select the Status field and use the spacebar to toggle it
ON or OFF.
10
Repeat steps 1-9 for each additional parameter set in the
table.