Asante Technologies 1012 - Manual (Page 92)

Page 3-36
Chapter 3 — AsantéBridge 1012 Local Management
You can reset the AsantéBridge 1012 in three different ways:
❏ Cycle the power . This resets both the bridge and hub
portions of the device. The repeater is not affected.
❏ Push the Reset button on the front panel. This resets
both hub and bridge.
❏ Send the Reset system command from the Configura-
tion Menu . This resets both the bridge and the hub.
Figure 3-21 Resetting the Bridge
1
Use the arrow keys to select the Reset system command.
2
Press return to reset the bridge.
Confirmation is required. The command executes only
after you have confirmed your choice.
Your display will begin to cycle through the bridge power-
on diagnostics and return to the
Local Management
Menu .
3
Enter control-z to return to the Local Management Menu.
Remember that a reset:
❏ Resets the bridge and hub statistics counters to zero
❏ Erases any packets in bridge and hub memory at the
time of the reset
❏ Prevents the bridge from forwarding or filtering data
flow until the power-on diagnostics have run to comple-
tion and the bridge has completed reconfiguring
❏ Erases dynamic forwarding addresses
Resetting the Bridge