Panasonic SCHC37EC - Manual (Page 12)

12
RQT9685
Others
As a factory preset, this unit will always turn off
automatically if there is no sound output and no
operation for 30 minutes.
To cancel this function
1
Press [SETUP] repeatedly to select “AUTO OFF”
and then press [OK].
2
Press [3, 4] to select “OFF” and then press [OK].
≥ To turn automatic standby on, select “ON” in step 2.
≥ This setting cannot be selected when “FM” is the source.
The brightness of this unit’s display can be changed.
1
Press [SETUP] repeatedly to select “DIMMER”
and then press [OK].
2
Press [3, 4] to select “ON” and then press [OK].
To cancel the dimmer, select “OFF” in step 2.
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1
Press [CD] to select “CD”.
2
Press and hold [CD] on the main unit and [3] on
the remote control until the main unit’s display
shows “REMOTE 2”.
3
Press and hold [OK] and [3] on the remote control
for at least 4 seconds.
To change the mode back to “REMOTE 1”, repeat the steps
above by replacing [3] with [4].
Troubleshooting
Before requesting service, make the following checks.
If you are in doubt about some of the check points, or if
the solutions indicated in the following guide do not
solve the problem, consult your dealer for instructions.
Humming heard during play.
≥ An AC mains lead or fluorescent light is near the cords. Keep
other appliances and cords away from this unit’s cables.
MP3 cannot be read.
≥ You may not be able to play MP3 if you have copied a
multi-session disc that has no data between sessions.
≥ When creating a multi-session disc, it is necessary to close the
session.
≥ The amount of data on the disc is too small. Set the amount of
data to above 5 MB.
Incorrect display or play will not start.
≥ Make sure that the disc is compatible with this unit. (> 4)
≥ There is moisture on the lens. Wait for about an hour and then try
again.
No response when [1/;] is pressed.
≥ Disconnect the USB device and then reconnect it. Alternatively,
turn the unit off and on again.
The USB drive or its contents cannot be read.
≥ The USB drive format or its contents is/are not compatible with the
unit. (> 4)
≥ The USB host function of this product may not work with some
USB devices.
Automatic standby
Display brightness
Changing the main unit and
remote control code
To return all settings to the factory preset
When the following situations occur, reset the
memory:
≥ There is no response when buttons are pressed.
≥ You want to clear and reset the memory contents.
1 Disconnect the AC mains lead. (Wait for at least
3 minutes before proceeding to step 2.)
2 While pressing and holding down [ Í/I] on the
main unit, reconnect the AC mains lead.
≥ “--------” appears on the display.
3 Release [ Í/I].
All the settings are returned to the factory preset. You will
need to reset the memory items.
Common problems
Disc operations
USB operations
SC-HC37~RQT9685.book Page 12 Friday, February 24, 2012 9:45 AM