Panasonic HX-A500H User Manual
Page 31
31
(ENG) SQT0251
When disposing of your used products, perform [RESET Wi-Fi SETTINGS] to delete personal
information from this unit.
≥
Disassemble after the battery runs out.
≥
If it cannot be removed smoothly, contact Panasonic’s Service Center.
≥
Keep disassembled parts out of reach of children.
1
Open the side cover, and remove
all of the 6 screws indicated in the
figure below.
≥
Use a cross-slot screwdriver (commercially
available).
2
Remove the connector
A
of the
flexible circuit board, and remove
the circuit board on the front side
(button side) of this unit.
3
Pull out the flexible circuit board
B
, and pull out the speaker
connector
C
upwards.
4
Remove the 4 screws indicated in
the figure below, and remove the
heatsink
D
.
5
Remove the connector
E
of the
camera unit, the built-in battery
connector
F
, and the NFC flexible
circuit board
G
, and lift up the
circuit board.
6
Remove the battery by using a
screwdriver.
Regarding the handling of used batteries
≥
Insulate the terminals with cellophane tape or
similar.
≥
Do not disassemble.
How to remove the battery
This figure describes the disposal of this unit, it is not instruction for repair. If
disassembled, repair is not possible.
HX-A500-SQT0251_mst.book 31 ページ ２０１４年４月１４日 月曜日 午後６時１５分