Panasonic TH65PF12EK - Manual (Page 58)

58
Shipping condition
PJLink™ Protocol
The network function of the unit conforms with PJLink™ class 1 and you can operate the following actions from your
computer using PJLink™ protocol.
• Display setup
• Display status query
Supported commands
Commands to control the unit with PJLink™ protocol are shown in the table below.
PJLink™ security authentication
Set “Panasonic” for the PJLink™ password.
• PJLink™ is a pending trademark in Japan, the United States, and other countries or areas.
Command Control Remark
POWR Power control
Parameter
0 = Standby 1 = Power “On”
POWR? Power status query
Parameter
0 = Standby 1 = Power “On”
INPT Input switch Parameter
First byte: 1 (RGB) fi xed
Second byte: Input position (from 1)
INPT? Input switch query
AVMT Shutter control Parameter
10 = Picture On (picture mute deactivated), 11 = Picture Off (picture on mute)
20 = Audio On (audio mute deactivated), 21 = Audio Off (audio on mute)
30 = Shutter mode Off (picture and audio mute deactivated)
31 = Shutter mode On (picture and audio on mute)
AVMT? Shutter control query Parameter
11 = Picture Off (picture on mute)
21 = Audio Off (audio on mute)
30 = Shutter mode Off (picture and audio mute deactivated)
31 = Shutter mode On (picture and audio on mute)
ERST? Error status query Parameter
First byte: Means fan error. 0 or 2.
Second byte: 0
Third byte: 0
Fourth byte: 0
Fifth byte: 0
Sixth byte: Means other error. 0 or 2.
Meaning of the 0 – 2 settings:
0 = Error is not detected, 2 = Error
LAMP? Lamp status query Not supported
INST? Input switch list query Parameter
11: Computer input
12 - 16: Slot 1 input (INPUT1A)
Slot 1 input (INPUT1B)
Slot 2 input (INPUT2A)
Slot 2 input (INPUT2B)
Slot 3 input (INPUT3)
Numbers greater than 12 are depending on the slot installation condition
NAME? Projector name query Returns empty character (no name information)
INF1? Manufacturer name query Returns “Panasonic”
INF2? Model name query Returns “TH-65PF12” (for 65-inch model)
INFO? Other information query Returns version number
CLSS? Class information query Returns “1”