Panasonic CYVMR5800N - Manual (Page 11)

Specifications E
N
G
L
I
S
H
18
CY-VMR5800N
23
E
N
G
L
I
S
H
17
CY-VMR5800N
22
Maintenance
To Prevent Damage to the System Exterior
Do not apply pesticides, benzine, thinner or other volatile
substances to the unit.
The cabinet surface primarily consists of plastic materials.
Do not wipe with benzine, thinner or similar substances
because this will results in discoloration or removal of the
paint.
When a cloth with a cleansing chemical is used, follow the
caution points.
Do not leave the unit in contact with rubber or vinyl prod-
ucts for long periods of time.
Do not use cleansers which have polishing granules
because this could damage the surface of the unit.
Clean Dirt by Wiping Lightly with a Soft Cloth
When the unit is dirty, wipe with a well-wrung cloth dipped in a kitchen cleanser (neutral) diluted with water and
then go over the same surface with a dry cloth.
(Since there is the possibility of water drops getting inside of the unit, do not directly apply cleanser to the sur-
face.)
❐ Overall System
Power supply: 12 V DC (11 V–16 V), test voltage 14.4 V, negative ground
Current consumption: Less than 1.5 A
Usage temperature range: 0 xC to 40 xC
Storage temperature range: j 20 xC to 80 xC
❐ Display Unit
Liquid crystal panel: 5.8q wide
Screen dimensions:
Width: 127 mm
Height: 74 mm
Diagonal: 147 mm
Number of pixels: 280 800 pixels (234 verticalk400 horizontalk3)
Display method: Transparent color filter format
Drive method: TFT (Thin Film Transistor) active matrix format
Light source: Internal light (U-shaped, cold-cathode tube)
Output power (Internal speaker): 1 W
Speaker:
4 cm round speaker
Dimensions (WkHkD): 155k113k33 mm
Weight: 420 g
Note:
≥
Specifications and design are subject to modification without notice due to improvements in technology.
Alcohol
Pesticide
Wax
Tape
Adhesive
Tape
Benzine
Thinner
Kitchen cleanser diluted with water.
Wipe lightly. Go over the same surface
with a dry cloth. Wring well.
Caution:
≥
If water drops or similar wet substances get inside the monitor via the liquid crystal panel surface, it may
cause a malfunction.