Panasonic CYVMR5800N - Manual (Page 9)

E
N
G
L
I
S
H
14
CY-VMR5800N
19
E
N
G
L
I
S
H
13
CY-VMR5800N
18
Electrical Connections
Cautions:
≥
This product is designed to operate with a 12 V DC, negative ground battery system.
≥ To prevent damage to the unit, be sure to follow the connection diagram below.
≥ Remove approximately 5 mm of protective covering from the ends of the leads before connecting.
≥ Do not insert the power connector into the unit until the wiring is completed.
≥ Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables
and keep cable terminals free from touching any metal parts.
≥ Note that if your car has a driving computer or a navigation computer, disconnecting the battery cables
may cause the contents of memory for these computers to be lost.
≥ All other installation methods require the use of dedicated metal fittings. Consult with a qualified servic-
ing engineer or your dealer if other methods are required.
❐ Wiring Diagram
ACC
(Red)
(Black)
Fuse 3 A
ACC power lead
To ACC power, _12 V DC.
Ground lead
To a clean, bare metallic part of the car chassis.
RGB/control cord
To the RGB-OUT connector of the Panasonic
mobile navigation system (CN-DV1800EN,
CN-DV2000EN, etc.).
Color LCD monitor
Power connector 2
1
Notes:
≥
Be sure to fully plug in the connector.
≥ The RGB input cord is applicable only to Panasonic mobile navigation system (CN-DV1800EN,
CN-DV2000EN, etc.).
Example combination
≥
Mobile navigation system (CN-DV1800EN)
❐ Basic system configuration
Notes:
≥
Be sure to fully plug in the connector.
≥ Refer to the operating instructions for the connected devices, in addition.
≥ The RGB input cord is applicable only to Panasonic mobile navigation system (CN-DV1800EN,
CN-DV2000EN, etc.).
Mobile navigation system
(CN-DV1800EN)
RGB-OUT
RGB
CY-VMR5800N
Power connector
RGB cord
(supplied to CN-DV1800EN)
2
Insert the connector
obliquely.