Nieco JF64-BG - Manual (Page 11)

11
C.2 lighting Procedures
1. Broiler is
centered under
hood and
plugged in
2. Gas valve is
open when
handle is in line
(parallel to) the
pipe
3. Turn ventilation
system on
The JF64-BG is equipped with automatic ignition. When the broiler is turned on, a hot surface ignitor turns on 5 sec-
onds before the flow of gas. Gas then flows to all of the burners. If the burners are not lit within 10 seconds, the con-
trol will reset and try again for 10 seconds. This occurs 3 times. If the broiler does not light after the third attempt, the
ignition failure light will flash and the main on/off switch must be cycled to repeat the procedure. If this still doesn’t light
the broiler, see the MANUAL IGNITION instructions.
WaRnInG
THe VenTIlaTIon sYsTeM MUsT be
on aT all TIMes DURInG bRoIleR
oPeRaTIon. oPeRaTInG bRoIleR
WITHoUT PRoPeR VenTIlaTIon Is a
seVeRe fIRe HaZaRD.
noRMal IGnITIon
PRe-lIGHTInG PRePaRaTIon
Nieco Corporation - Model JF64-BG
1. Turn the MaIn PoWeR sWITCH on. 1.
2.
2. Allow broiler to heat for 45 minutes before cooking.
ManUal IGnITIon
1. Remove the discharge awning. Turn the MaIn PoWeR
sWITCH on. Hold a lighter/match to the first upper burner
on the discharge end until the burner lights. Once the first
burner is lit, verify that all burners have ignited.