Nieco JF64-BG - Manual (Page 17)

17 Nieco Corporation - Model JF64-BG
1. Pull the release pin.
2. Lift wire belt feeder bases up and off.
3. Wash, rinse, and sanitize in the 3-compartment
sink.
REASSEMBLY: Pull the release pin and place
feeder base in position.
Wire Belt Feeder Base (If equipped)
Feed End
Tools
Instructions
3-Compartment Sink
Clean: Every 4 hours
Scrub Pad
1. Slide the feeder cover towards you until it
comes off.
2. Wash, rinse, and sanitize in the 3-compartment
sink.
Feeder Cover (If equipped)
Feed End
Tools
Instructions
3-Compartment Sink
Clean: Every 4 hours
Scrub Pad