Nieco JF64-BG - Manual (Page 30)

30 Nieco Corporation - Model JF64-BG
1. Scrape each shaft of both belts on the
discharge end with the wide end of the shaft
cleaning tool. The tool is located on the clip on
the back of the broiler.
2. Wipe shaft cleaning tool with a towel.
Chain Shafts
Discharge End
Tools
Instructions
Clean: Daily
Shaft Cleaning
Tool
Belt Adjustment
As Needed
Tools
Instructions
1. Remove return slide and stripper bar.
2. Loosen slotted crossbar bracket with 7/16 wrench.
3. Pry on shaft to adjust belt.
4. Tighten bolts.