Nieco JF64 - Manual (Page 22)

22 Nieco Corporation - Model JF64-3G
1. Use a flat head screwdriver or box cutter to
clean the slots on the pilot orifices.
Pilot Orifices
Interior
Tools
Instructions
Clean: Monthly
Flat Head
Screwdriver
1. Remove the left side control box cover.
2. Remove the ceramic boot from the back of the
flame sensor.
3. Loosen the wing nut holding the flame sensor
in place.
4. Remove the flame sensor and clean the metal
tip with a DRY, clean scrub pad.
Flame Sensor
Side
Tools
Instructions
Clean: Monthly
Scrub Pad