Nieco JF64 - Manual (Page 24)

24 Nieco Corporation - Model JF64-3G
1. Scrape shaft of each belt on the discharge end
with the wide end of the shaft cleaning tool. The
tool is located on the clip on the discharge end of
the broiler.
2. Wipe shaft cleaning tool with a towel.
Chain Shafts
Tools
Instructions
Clean: Daily
Shaft Cleaning Tool
INNER HEAT SHIELDS
BELT ADJUSTMENT
Tools
Tools
Instructions
Instructions
Shaft Cleaning Tool
1. Reach between the belt with the Shaft Cleaning
Tool to scrape deposits from the inner shield.
Discharge End
1. Remove Discharge Awning and stripper blade.
2. Loosen slotted crossbar bracket.
3. Pry on shaft to adjust belt.
4. Tighten bolts.
Clean: Daily
As Needed