Vaddio CeilingVIEW 70 Manual - Manual (Page 3)

CeilingVIEW 70 PTZ – Document 010-2304-000 Rev. E
Page 3 of 14
Note: If camera is to be controlled as part of a multi camera system, please
refer to the section CHANGING CAMERA DEFAULT SETTINGS located on
Page 6 of this manual.
To mount the CeilingVIEW 70 PTZ:
1) Attach a string or plumb bob to the ceiling tile with a thumbtack.
2) Position the string directly over ample table space or work
surface to allow easy document and object positioning.
3) Using a sharp utility knife, score a 6-3/4" diameter circle into the
front of the tile centered on the string.
4) Carefully cut out the 6-3/4" hole.
5) Place the tile support rail on the backside of the tile and center
over the hole. Carefully place camera in cutout hole from the
back of tile (see Figures 3 and 4) and attach to support rails.
6) Using the supplied thumbscrews and washers, attach the
support rails to the CeilingVIEW 70 PTZ camera (see Figure 4).
Place rail edge between two washers and tighten thumbscrew
securely.
Note: The thumbscrew sits on top of the rail, not through
the holes on the rail.
Step by Step
Mounting
Instructions
CAMERA
THUMB SCREW
24" BRACKET
WASHERS
Figure 3:
Side View of
CeilingVIEW 70 PTZ
Camera and back box
For installation
reference, the cutout
area by the IR detector
cable hole cable hole is
to the front of the
camera.
Figure 4:
Side View and Close-up
of Camera module and
support rail attachment.