Vaddio CeilingVIEW 70 Manual - Manual (Page 5)

CeilingVIEW 70 PTZ - Document 010-2304-000 Rev.E
Page 5 of 14
10) The camera and ceiling tile should be carefully replaced in the
suspended ceiling at this time.
11) Locate the white trim ring assembly and plug the IR cable into
the IR board connector on the trim ring lip (see Figure 8). Take
care not to pull any more than about 2 inches of cable from the
camera enclosure. The connectors will fit together only one way
with a positive click. (
Note: DO NOT hang the trim ring from the
camera by the IR cable)
Carefully move trim ring into position on
bottom of ceiling tile while feeding IR cable back into camera
enclosure and secure with the two supplied white screws.
With the Cat.5 cable routed from the POWER/VIDEO jack on the
back of the camera to the Quick Connect Box; connect the supplied
Vaddio PowerRite power supply. The camera will activate and
move to the “HOME” position and the S-Video and Composite Video
signals will be live and viewable.
The Camera can be controlled with the Sony RM-EV100 IR Remote
Controller or through RS-232 using VISCA control protocols.
The Sony RM-EV100 IR Remote Controller controls the following
functions when used with a CeilingVIEW 70 PTZ (see Figure 9). A
fresh set of AA batteries (not included) should be installed in the
provided Sony remote control. To operate, aim remote at camera
and depress desired button.
Finishing Up
Figure 8:
Connecting the IR
sensor on Trim Ring
to the IR cable
Initial
Camera
Power Up
CONTROLLING
THE CAMERA
IR Remote