Vaddio ControlVIEW XHD - Manual (Page 20)

ControlVIEW XHD
ControlVIEW XHD Manual 341-917 Rev. C Page 20 of 24
Appendix 1: RS-232 Control
The ControlVIEW XHD has six (6) discrete camera control ports which eliminates the need for daisy-
chaining control cabling. With ControlVIEW XHD, all cabling configurations are home-run wiring
configurations. Each Channel will auto-configure the input channel for control of the camera attached.
Vaddio uses simple control protocols to accomplish custom programming with the ControlVIEW XHD.
The Communication Specification, API and Programming Language are listed below and definitions are
listed on the next page. Note: All commands must be followed by a carriage return.
Communication Specification
Communication Speed: 9600 bps (default)
Start bit: 1
Stop bit: 1
Data bits: 8
Parity: None
No Flow control
Control Port - RS-232 on DB-9F Connector
PIN# Signal
2) TXD
3)
RXD
5) GND
All other pins - Unused
API and Programming Language
+--------------------------------------------------------------------------+
| Vaddio ControlVIEW XHD |
+--------------------------------------------------------------------------+
| ? - This Menu |
+------------------------ System Access -----------------------------------+
|Power x- Power(On/Off) |Mix - Mix/FTB Button |
|Input x- Switch to Input(1-6) |Cut - Cut Button |
|Store x- Store Preset(1-138) |Wipe - Wipe Button |
|Preset x- Enable/Disable/Go to Preset(1-138) |
|Camera x- Switch to Camera(1-6) Video Input not changed |
+--------------------------------------------------------------------------+
|WipeSel x- Effect select:(0-10) 0:Wipe R>L,1:Wipe L>R, |
| 2:Wipe Top>Bot,3:Wipe Bot>Top,4:Wipe LR>UL,5:Wipe LL>UR,6:Wipe UR>LL,|
| 7:Wipe UL>LR,8:Wipe Out>Cnt,9:Wipe L>Cnt<R,10:Wipe T>Cnt<B |
+--------------------- Preset Pan, Tilt, Zoom------------------------------+
|PanSpeed x- Preset Pan Speed (1-24) |TiltSpeed x-Preset Tilt Spd(1-20)|
|ZoomSpeed x- Preset Zoom Spd (1-7) |Home - Home Camera |
+--------------- Camera ----------------+----------------------------------+
|Move x,x- (Up/Down/Stop/Left/Right),Value |
|Zoom x,x- (In/Out/Stop),Value |
+--------------------- System Setup and Utilties---------------------------+
|SetDefault x- Set Default Preset(1-72) |Tally - Idle(High/Low) |
|DspCams - List connected cameras |IdleRtn x- Default Timer(0-60) |
|Reset - 'CPU'Reset |SerialEcho x- Echo Serial (On/Off)|
|ClearAll - Clear all presets |SerialInfo x- Status (On/Off) |
|SaveConfig - Manual Config Save |Version - Firmware Version |
|Rescan - Rescan cameras |Config - List Config Settings|
|InitTrig - Init Idle Trig State |ResetVideo - Re-Load Video config|
|Triggers x- Enable/Disable |JSD70 x- On/Off/Timer(0-255) |
+--------------------------------------------------------------------------+