Vaddio ControlVIEW XHD - Manual (Page 6)

ControlVIEW XHD
ControlVIEW XHD Manual 341-917 Rev. C Page 6 of 24
ControlVIEW XHD Back Panel I/O (Figure 3):
11. Trigger Inputs 1 – 24: The first 24 trigger inputs are on Phoenix-type connectors. Trigger inputs 1 –
12 can be programmed in First Step, Last Step and Multi Step operation, which allows the live
camera to zoom in or out to multiple trigger positions. Supports Vaddio AutoVIEW IR, StepVIEW,
TouchVIEW and MicVIEW trigger inputs.
12. Power Input: ControlVIEW XHD operates on an 12 VDC, 3 Amp PowerRite power supply.
13. Control Inputs: For each PTZ camera connected, a homerun CAT-5 cable is run to the RS-232
input of the camera. This allows the pan, tilt and zoom position to be sent to the camera for preset
camera positions. If the input is not a PTZ camera (DVD player, computer, etc.), then this port is not
used.
14. Video Inputs: The video inputs can accept the SD (composite or Y-C), HD (Y, Pb, Pr) or RGBHV
signals (each input is independent and selectable via internal menu). See the Video Resolutions
table at the back of the manual for all supported input/output video signals.
15. RS-232 Thru*: The RS-232 Thru connection allows the user to send RS-232 signaling through
ControlVIEW XHD to other control equipment, such as third-party control systems (available on a
future release of firmware).
16. RS-232: The RS-232 input allows the ControlVIEW XHD to receive commands from third-party
hardware. This port is also used as a connection for updating firmware on the system.
17. Program Outputs: Delivers the same SD (composite or Y-C), HD (Y, Pb, Pr) or RGBHV signal
(selectable via internal menu) on both connectors. See the Video Resolutions table at the back of the
manual for all supported input/output video signals.
18. Link In / Link Out: The Link In / Link Out connectors allow ControlVIEW XHD to seamlessly integrate
with Vaddio’s Precision Camera Controller, when used as an operator controlled seamless switcher.
19. Network*: The Network port is a 10/100 mbps Ethernet port to allow remote access of the system for
troubleshooting and status (available on a future release of firmware).
20. Tally Outputs – Allows for connecting ControlVIEW XHD to external Tally inputs such as Vaddio’s
PreVIEW HD monitors, Quick-Connect CCU and other third-party tally sources.
21. Trigger Inputs 25 – 72: Trigger inputs 25 - 72 are on two 25-pin connectors. Trigger inputs support
Vaddio AutoVIEW IR, StepVIEW, TouchVIEW and MicVIEW trigger inputs, as well as third-party
trigger devices.
* The RS-232 Thru and Network ports will be active on a future software release.
Vaddio accessory cables for SD (composite) and HD/SD component (YPbPr) are sold separately.
Within the Menu System there is a selection of formats for SD video including Letterbox, Cropped and
Squeezed. These selections were added to better blend SD signals with HD signals.
Note: Strain relief for the 15-pin connectors is recommended on the back of the ControlVIEW XHD.
11
12 13 14 15 16 17 18
19 20 21