Vaddio EZIM CCU Slot Card - Manual (Page 4)

WallVIEW CCU HD-18
WallVIEW CCU HD-18 Manual 341-889 Rev. C Page 4 of 18
5. RS-232 In & IR Out – The RS-232 accepts modified VISCA™ protocol for camera control, as well
as transmits IR signaling received by the IR receivers, which can be transmitted to third party
devices.
6. DIP Switch Settings – Settings for IR remote, baud rate, SD output format, image flip can be
configured on these switches. See page 7 for additional information switch settings.
7. HD Video Select – A rotary switch allows the user to choose the component HD output video
resolution and format. See page 7 for additional information on switch settings.
8. 12 VDC Input – NOTE: The power input is not used with the WallVIEW CCU HD-18 system. This
is only used on the standard, ClearVIEW HD-18 camera.
9. YPbPr Video Output – Component HD video is fed through the DB-15 connector.
10. SD Video Output – Standard definition video is fed through the BNC connector.
11. EZ Port – CAT-5 cable (up to 100 feet) is connected to the Quick-Connect SR. The EZ-Port
supplies power to the camera and delivers component HD video up to 100 feet.
12. EZIM CCU Card – Slot card for sending power (36 VDC) to the HD-18 camera and delivering video
to the Quick-Connect CCU through the card in the back of the camera base.
5
6
7
8
9
10
11
12
Figure 3: WallVIEW CCU HD-18 camera (back)