Vaddio EZIM CCU Slot Card User Manual
Page 7
WallVIEW CCU HD-18
WallVIEW CCU HD-18 Manual 341-889 Rev. C
Page 7 of 18
First Time Set-up with the WallVIEW CCU HD-18:
WallVIEW CCU HD-18 was designed to be exceptionally easy to use and operate. There is
documentation at the back of the manual for pin-outs for all of the connectors on the WallVIEW CCU HD-
18 camera.
Getting Started:
First, set up the HD and SD output resolutions for the camera, along with IR output, baud rate and image
flip. On the next page are the options for the switches that are found on the back of the camera.
Figure 5:
Dip Switch and HD Video Output Resolution Setting Options for the HD-18 Camera
Note:
The Test Bars are non standard, but are 75% YCbCr Color Bars and are intended as a
convenience for testing the signal path only.
• IR 1, 2 & 3: These settings, using switches 1 & 2, determine the IR frequency of the IR remote control
that was supplied with your camera. The IR remote has the capability of operating up to three different
PTZ cameras from one remote, using the selector buttons at the top of the remote.
• IR Out: The IR output is sent on the RJ-45, RS-232 jack on the back of the camera. NOTE: When
using the Quick-Connect CCU, the IR output must be in the Off position (up).
• Baud Rate: The options for baud rate are either 9600 or 38,400 for RS-232.
• SD Output Frequency: Select either NTSC or PAL as the output for the camera’s SD signal that is
transmitted on the BNC connector.
• SD Output Size: Three options are available for the SD output, select from crop, squeeze or letterbox.
• Image Flip: Turing Image Flip on (switch down), will allow the camera to be inverted.
• Test Bars: Turning this switch on will override the camera video output and send test video bars from
the camera to the CCU to allow more accurate setting of the video level at the CCU.
• Switch 10: This switch is unused, and should be left in the OFF position.
RS-232 Cabling
For RS-232, use a standard CAT-5 cable (568B termination for RJ-45 connectors) from the RS-232 port
on the back of a Vaddio ProductionVIEW camera controller or switcher. If the camera will be connected
to a third-party control system (such as AMX or Crestron), a DB-9 to RJ-45 adapter cable is supplied with
the camera for RS-232.
IR Output – Switch 3
When operating the HD-18 camera with the Quick-Connect CCU, the IR Output must be set to the OFF
position on the back of the camera. If it is not turned off, it will interfere with proper operation of the PTZ
camera.
IR 1
1 & 2 UP
ON
SD
NTSC
SD
PAL
SD 4:3
6 & 7 UP
SD
LB
IMAGE
FLIP
OFF
ON
ON
DIP SWITCH SETTINGS
8
1
2
3
4
5
6
7
9
10
HD VIDEO SELECT
720p/59.94
1080i/59.94
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
1080p/59.94
1080p/60
720p/50
1080i/50
1080p/50
2
1
5
4
3
7
6
8
10
9
ON
IR 2
ON
IR 3
ON
IR
OUT
OFF
9600
bps
38400
bps
SD
SQ
TEST
BARS
OFF
10
OFF
480i/29.97
1080p/25
1080p/30
576i/25