Vaddio Outdoor Pendant Mount Dome for Vaddio HD-20/HD-19/HD-18 - Manual (Page 6)

DomeVIEW HD Weather-Resistant 12” Outdoor Pendant Mount Dome
DomeVIEW HD Weather-Resistant 12” Outdoor Pendant Mount Dome Manual 342-0188 Rev. B Page 6 of 8
Camera Platform and Heater/Blower Components:
When powered up, the fan will run continuously. The heater resistor will turn on at 45° F (7.22222 ºC) to keep the
contents warm. Operating range with the heater blower is -10°F to 115°F (-23.3ºC to 46.1ºC).
Step 5:
Connect the 18/2 cable to the green Phoenix type connector as shown (circuit board is marked +24VDC and
GND).
Step 6:
Take the provided ¼”-20 x 5/8 Screws and attach the HD-18 camera to the camera platform.
NOTE:
If using the HD-20 camera, attach the camera with the provided ¼”-20 x .375” screws. Also, take the thee
(3) .75” long 10-32 threaded M to F .5” Hex stand-off extensions and attach them to the Three (3) 2.5” long 10-32
threaded F to F .5” Hex stand-offs in the bottom of the can. The HD-20 is about ¾” shorter than the HD-18 and
needs this small boost.
Step 7:
Set the camera dip and rotary switches (functions and video resolutions prior to installing it in the dome). Re-install
the Universal Mounting Platform inside the dome with the camera attached. Slip the keyholes over the screws in
the stand-offs and tighten down all three platform screws Connect the Cat-5e cables according to the manual
that was included with the camera package purchased, making sure the cables are tucked up behind the
mounting plate to avoid interference with the PTZ camera movement and away from the heating resistor and fan.
Fan
Key-hole
Slots x 2
Metal
Heater
Resistor
Two ¼”-2 holes
for camera
attachment
Heater/Blower
Circuit
+24VDC
GND
Through
Hole for
Screw
18/2 Cable
(not supplied)