Vaddio ProductionVIEW HD MV - Manual (Page 18)

ProductionVIEW HD MV
ProductionVIEW HD MV Manual - Document Number 342-0241 Rev G Page 18 of 36
Optional TeleTouch LCD Monitor Touch Screen
Software, Hardware and how it works
Details:
1) Program video output window with red tally border.
2) Preview video output window with green tally border.
3) Video window name and output resolutions listed under Program and Preview windows.
4) Up to 6 input windows, labeled INPUT 1 through INPUT 6, with input resolutions listed. These smaller input
windows also have Program and Preview tally borders.
5) Up to 12 preset video thumbnails (still shots) allow the user to see a still image of the camera position before
calling up a preset into the input windows.
6) Standard base for the 22” monitor. The base can be removed and a 100mm x 100mm VESA mount can be
used instead of the base.
7) Standard control features with the Take button and choice of fade, cut or wipe transitions. Transitions will not
appear on the TeleTouch multiviewer preview monitor. Transitions appear on the Program output only.
8) One (1) of six (6) standard video windows with blue borders (blue indicates that the window has not been
chosen for Program or Preview).
To operate the ProductionVIEW HD MV with the Touch Screen:
1) Plug in all the sources (PTZ Cameras, Video Whiteboard, PC etc…). Try to get the sources at the same
resolution or close, as this enhances switching speed. Once the sources are plugged in and Steps 1 & 2 was
performed on the previous page then move on.
2) For simple switching, touch any of the six (6) standard video input widows. This touch will elevate that input
window to the larger Preview screen and both the standard input screen and Preview screen are given green
tally boarders and are cued up for the Program shot.
3) Touch the larger Preview screen with the green tally border (or touch the TAKE button) to “take” the Preview
shot to the Program output. The Preview shot will move to Program and both the Program output and the
standard input window will be given red tally borders. Meanwhile, back at the ranch, the previous Program
window and standard input window will be moved to the Preview position and given the green tally boarders.
4) The TAKE can be performed 2-ways; by touching the large Preview window with the green tally border or by
use of the large grey TAKE button (#7 above). Other buttons allow the operator to switch between fades,
wipes or cuts. The time for these transitions is still controlled by the console.
➁
1080p/60 1080p/60
➀
➂
➄
➃
➇
➅
➆