Vaddio Quick-Connect Universal CAT-5 - Manual (Page 11)

WallVIEW Universal CCU Cat-5 Version
Vaddio WallVIEW Universal CCU Cat-5 Version. Document Number 342-0512 Rev C Page 11 of 20
Image: The HD-19 Universal CCU Control Screens
The HD-19 Main Menu screens differ from the HD-20 and HD-18 in that there are two (2) camera pages of
Menus that offer similar controls but also include Brightness and AGC on Page 1 with Shutter, Noise reduction
and Image Stabilization on page 2. The Version Screen, Cat-5 Adjustment and Configurations and Display
control menus are virtually identical as the HD-20 or HD-18 except for the numbers on the Version screen.
A few notes about Super Noise Reduction and Image Stabilization:
Use these features sparingly as there are performance trade-offs which are mostly, sort of, kind of well known,
but here goes:
Super Noise Reduction: Please use the noise reduction, if needed, on the lower settings. Too much noise
reduction will tend to blur images with a lot of movement. So consider the subject matter, if you are shooting a
Roller Derby, use as little as possible, conversely a well framed shot of paint drying can use more noise
reduction…as needed, of course.
Image Stabilization: It is great for a hand held camcorder, an operator with a tripod and on a mount on the front
of a church balcony. But in the absence of shaking and vibration, try not to use image stabilization in general.
Using a camera with image stabilization with a joystick can be frustrating as the image will not start or stop with
the movements of the joystick because it is buffering frames to apply stabilization and there will be a difficult lag
to anticipate. Anticipating for buffered frames isn’t anything we like people to have to think about.
Installation Basics:
The WallVIEW CCU system was specifically designed for installation on a vertical wall surface with
Cat-5 cable connectivity for Video, Power and Control signaling (three Cat-5 cables are required).
Installation is simplified in that no custom 8-Pin mini-din cables or expensive plenum coax cables are
needed and no power outlets are required near the camera bracket. All cabling is routed to the
head-end using Cat-5 cables using standard straight through RJ-45 connectors (568B termination).
“Pass-thru” type RJ-45 connectors should never be used.
Mounting and Installation Instructions for the CONCEAL Wall Mounting System:
Step 1: Determine Camera Mount Location
When locating the camera, consider viewing angles, lighting conditions, possible line of site obstructions and
check for in-wall obstructions where the camera is to be mounted. Pick a mounting location to optimize the
performance of the camera. After determining the optimum location of the camera system, route the required
three (3) Cat-5 cables from the camera to the head-end. Mark the Cables: POWER, VIDEO and CONTROL.
The three (3) Cat-5 cables should feed-through a 1” (25.4mm) opening (circular or square shape) centered in the
rectangular slot located on the rear flange of the CONCEAL Wall Mount Bracket.
Note: Do not cut out the entire rectangular slot opening in the wall! This will not allow the two lower wall
anchors to correctly fasten the Conceal Wall Mount to the wall.
If the bracket is to be mounted on a 2-gang wall box, use the screws supplied with the wall box cover plate to
attach the CONCEAL Wall Mount Bracket.
If mounting to drywall with wall anchors, use the four (4) quality wall anchors/screws provided
HD-19 Main Menu Screen #1 HD-19 Main Menu Screen #2
CAT-5 CCU HD-19
RED
407 GAMMA 101
BLUE 571 DETAIL 04
CHROMA 50 IRIS AUTO
Bright 50 AGC LOW
CAT-5 CCU HD-19
SHUTTER AUTO
SNR
ON
DIS OFF