Vaddio Quick-Connect Universal CAT-5 - Manual (Page 12)

WallVIEW Universal CCU Cat-5 Version
Vaddio WallVIEW Universal CCU Cat-5 Version. Document Number 342-0512 Rev C Page 12 of 20
Note: The mounting holes are slotted and are at 90° opposing to provide easy leveling. Level the mount and
tighten the mounting screws.
Note: Check all Cat-5 cables for continuity in advance of final connection. Plugging the POWER Cat-5
cable into the wrong RJ-45 may cause damage to the camera system and void the warranty!
Step 2: System Wiring
Follow the sample wiring diagrams for connecting the Cat-5 cables to the camera and Quick-Connect Universal
CCU Interface. Additional diagrams are available on the Vaddio website.
Connect the camera side as follows:
 Connect the POWER Cat-5 to the Power RJ-45 on the EZIM CCU Slot Card.
 Connect the VIDEO Cat-5 to the Video RJ-45 on the EZIM CCU Slot Card.
 Connect the RS-232 control Cat-5 to the “RS-232 IN” RJ-45 on the top row of connectors on the camera.
Connect the Universal CCU side as follows:
 Connect the VIDEO Cat-5 cable to the VIDEO FROM CAMERA RJ-45 jack (yellow) on the Universal CCU.
 Connect the RS-232 Cat-5 cable to the RS-232 TO CAMERA RJ-45 (Blue) on the Universal CCU.
 Wait to connect the POWER Cat-5 cable until later.
Step 3: Secure the Camera To the CONCEAL Wall Mount Bracket
After all cables are attached to the camera, place the camera onto the camera mount and insert the two 1/4”-20
screws into the camera through the two-screw holes in the bottom of the mount. Note: Be sure to align each side
of the camera evenly to all sides of the CONCEAL Wall Mount Bracket before final tightening of the mounting
screws.
Step 4: Install the CONCEAL Lower Cover Plate
Attach the CONCEAL lower cover plate. Slide lower cover plate from front of the mounting bracket toward the
rear of the bracket. The two (2) rear locking tabs will need to be guided into position first and will lock in place as
the lower cover plate is pushed toward the rear of the mounting bracket and the front two (2) tabs are inserted.
CONCEAL Wall Mount Bracket:
Cabled and Attached to Wall
Fig. 2: Vaddio HD-18 Camera aligned
and attached to the CONCEAL Wall
Mount Bracket (by two-(1/4”-20)
screws in the bottom of the mount)
CONCEAL Lower Cover Plate
with Locking Tabs
CONCEAL Lower Cover
Plate locked in place