Vaddio REVEAL - Manual (Page 8)

REVEAL IN-Wall Cameras
REVEAL IN-Wall Camera Manual Document Number 342-0059 Rev. A Page 8 of 28
Step 6:
The REVEAL System uses two (2) Cat. 5e cables. One Cat. 5e cable will to power the camera and return HSDS video
signals, and the 2
nd Cat. 5e cable will handle the RS-232 control signals. Please TEST and label the POWER/VIDEO and
the CONTROL cables accordingly.
On the bottom of the camera, remove the Pan
locking screw as indicated on the right. The
purpose of the screw is to hold down the
pan/tilt mechanism securely during shipment.
Please do not connect power to the REVEAL
before removing the screw
Route two (2) labeled Cat. 5e cables into the wall cavity and through the opening in the drywall. Plug the POWER/VIDEO
cable into the RJ-45 jack marked EZCAMERA POWER & HD VIDEO and plug the CONTROL RJ-45 into the RS-232 & IR
OUT jack (see below). At the Quick-Connect system, connect the corresponding Cat. 5e cables to the POWER & HD
VIDEO port and the RS-232 OUT port. Please do not cross-connect these cables, instead please label the cables and
avoid the “trial and error” connection technique.
TEST THE CAMERA AT THIS POINT TO ENSURE THE REVEAL WORKS
PROPERLY . (Refer to the Switch Settings section for HD video output resolutions and dip switch settings on page 11).
Step 7: Ease the Camera Module back into the wall opening with the connected Cat. 5e cables as illustrated below:
EZCAMERA
POWER &
HD VIDEO
RS-232 &
IR OUT
Tilt the enclosure and
allow the connectors
to enter the wall
opening before the
bottom of the
enclosure.
Slide the enclosure
straight back into the
wall opening and prior
to securing the camera
to the drywall, pull out
the level….again.
Back-cutting the
drywall and taping the
edges will aid
installation.
Remove the pan locking
screw prior to connecting
power to the REVEAL