Vaddio SDI Slot Card for Vaddio ClearVIEW HD-18/20 User Manual
Page 12
WallVIEW CCU HD-18 HD-SDI
WallVIEW CCU HD-18 HD-SDI Manual 341-988 Rev. A
Page 12 of 26
EZIM HD-SDI Slot Card Output Resolutions:
The HD-SDI/SDI output of the Slot Card will be dependent on the output signal being fed into the slot card
from the Vaddio HD-18 camera. The HD Video Resolutions are selected via the 16-position rotary switch
on the HD-18 camera. A label has been placed on the bottom of the camera for reference. The HD-SDI
and the YPbPr are concurrent outputs at the same resolution. For example, when the rotary switch is set
to the “0” position, both the HD-SDI and the YPbPr output will be 720p/59.94.
Position
Resolution
SMPTE Std.
Position
Resolution
SMPTE Std.
0 720p/59.94
SMPTE
292M
8
576i/25* SMPTE
259M
1 1080i/59.94
SMPTE
292M
9
NA
2 1080p/59.94**
SMPTE
424M A
NA
3 1080p/60**
SMPTE
424M
B
NA
4 720p/50
SMPTE
292M
C
NA
5 1080i/50
SMPTE
292M
D
NA
6
1080p/50**
SMPTE 424M
E
1080p/30
SMPTE 292M
7 480i/29.97*
SMPTE 259M
F
1080p/25
SMPTE 292M
*A firmware upgrade to the HD-18 may be required to enable standard definition SDI outputs.
**Tested with HD-SDI Receivers in the ProductionVIEW HD-SDI Console. Compatibility with other 3Gb/s
Switchers and monitors may differ***.
***Certain equipment may not be capable of all the resolutions listed and therefore may not function
properly. If a certain resolution does not seem to work appropriately, please make sure that the
displaying device is properly configured, capable of the resolution that is chosen and is cabled correctly.
Furthermore, just because a resolution is listed on the above table, in this manual, does not mean the
display device can reproduce it accurately. There are many variables and not all monitors are created
equal. If you can’t get a certain resolution to display correctly, simply choose a different resolution.
Alternatively, if a resolution on this table is not listed, the camera and Slot Card will not output that
resolution. Please select a resolution on the table that the HD-18 Camera and HD-SDI Slot Card,
mixer/switcher/scaler/controller (i.e. ProductionVIEW HD-SDI), monitor and cable are all capable of
producing.
EZIM HD-SDI Slot Card Pin-Out Assignments for the POWER RJ-45 Jack
(This power jack to be used with the Quick-Connect CCU)
Power Connector RJ-45
Pin Signal
1) Power
+
2) Power
-
3) Power
+
4) Power
-
5) Power
+
6) Power
-
7) Power
+
8) Power
-
Rotary Switch on
Rear of HD-18
Camera
12345678