Vaddio SDI Slot Card for Vaddio ClearVIEW HD-18/20 - Manual (Page 21)

WallVIEW CCU HD-18 HD-SDI
WallVIEW CCU HD-18 HD-SDI Manual 341-988 Rev. A Page 21 of 26
Other General Information:
Care and Cleaning
• Do not attempt to take any of these products apart at any time. There are no user-serviceable
components inside.
• Do not spill liquids or liquid type substances onto the HD-SDI Slot Card, the CCU or in the HD-18
Camera.
• Keep this device away from food or liquid or other immeasurably bad sticky or oily things.
• For smears or smudges on the products, wipe with a clean, soft cloth but do not attempt to clean the
exposed parts, ICs or connectors on the HD-SDI Slot Card.
• Do not use any abrasive chemicals at any time on any product.
Operating and Storage Conditions:
Do not store or operate the HD-SDI Slot Card under the following conditions:
• Temperatures above 40°C (104°F) or temperatures below 0°C (32°F)
• High humidity, condensing or wet environments or if left out in the lawn overnight
• In inclement weather, especially when it is bad
• Dusty and explosive environments with more than a pile of dust in the air
• Dry environments with an excess of static discharge
• Under severe vibration
Restatement of Important Safeguards:
Read and understand all instructions before using. Do not operate any device if it has been dropped or
damaged. In this case, a Vaddio technician must examine the product before operating. To reduce the
risk of electric shock, do not immerse in water or other liquids and avoid extremely humid conditions.
Use only the approved power supplies provided with the system.
Use of any unauthorized power supply will void any and all warranties.
Do not use RJ-45 “pass-thru” connectors - they are gnarly and bad,
and should never be used on important, permanent installations.
Use standard RJ-45 connectors for best and consistent results.
Do not insert or remove the EZIM HD-SDI Slot Card into an HD-18
Camera when the camera is powered ON. Detach all power
connectors before installing or removing the HD-SDI Slot Card. The
EZIM HD-SDI Slot Card is not hot swappable.
FIRMWARE VERSIONS:
The firmware version V01.02.01 for the HD-18 camera that enables the HD-SDI Slot
Card to operate properly (dated May 20
th , 2010). If you have purchased an HD-18
PTZ camera before this date, a firmware update is required. The updates and
directions are on the Vaddio website (vaddio.com) and if assistance with the
download and update is needed, please contact Vaddio Technical Support at 800-
572-2011.