Vaddio SDI Slot Card for Vaddio ClearVIEW HD-18/20 User Manual
Page 9
WallVIEW CCU HD-18 HD-SDI
WallVIEW CCU HD-18 HD-SDI Manual 341-988 Rev. A
Page 9 of 26
Before Installing
• Locate the camera mounting location paying close attention to camera viewing angles, lighting
conditions, possible line of site obstructions, and checking for in-wall obstructions where the camera
is to be mounted. Pick a mounting location to optimize the performance of the camera.
• Pre-wire all cabling as required (see the wiring diagram example below).
• The Thin Profile Wall Mount for the HD-18 can be mounted directly to a 2-gang wall box or can be
mounted to the drywall using four dry wall anchors.
MOUNTING AND INSTALLATION INSTRUCTIONS
Step 1:
After determining the optimum location of the camera system, route the 1 (one) coax and 2 (two) CAT 5e
cables from the camera to the equipment head-end. The cables should feed-through the oval slot located
on the rear flange of the wall mount. If the bracket is to be mounted on a 2-gang wall box, use the screws
supplied with the wall box cover plate to attach the Thin Profile Wall Mount. If mounting to the drywall
with wall anchors, use the four (4) quality wall anchors. The mounting holes are slotted and are 90°
opposing to provide easy leveling. Level the mount and tighten down the mounting screws.
Step 2:
Installing the EZIM HD-SDI Slot Card:
•
Remove all power connections
and be
certain that the HD-18 camera is not
powered up before attempting to install
the EZIM HD-SDI Slot Card. Remove
the blank plate (1) that covers the card
slot opening. Retain the blank panel as
needed in case the Slot Card is ever
removed.
• Carefully slide the EZIM HD-SDI Slot
Card into the HD-18 Camera base and
let the self mating connectors (2)
engage. The camera base is notched
on either side of the card slot (3) to aid
in alignment. Push the Slot Card in
completely.
①
Figure 9:
Rear View of
HD-18 with
Blank Plate
Shown
Figure 10:
Rear View of HD-18
Showing Insertion of
the Slot Card
②
Please disconnect camera from power
before inserting or removing the EZIM
HD-SDI Slot Card.
③