Vaddio TRIO Solutions User Manual
Page 12
TRIO I/O and TRIO Mic Solutions
Vaddio TRIO MIC Solutions - Document Number 342-0568 Rev A
Page 12 of 16
TRIO
T
ABLE AND
C
EILING
M
IC
A
RRAY
I
NSTALLATION
Trio Table Mic
1) Pick up the TRIO table mic and flip it over to the bottom side (low degree of difficulty)..
2) Plug in RJ-45 cable originating TRIO MIC I/O Interface.
3) Align RJ-45 cable into cable tray for exiting out enclosure and place unit back on table.
Diagram: TRIO Table Mic Installation Diagram (bottom view)
TRIO Ceiling Mic Array
For some of the most obvious reasons, a ladder is required to install the TRIO Ceiling Mic Arrays.
Safety comes first, so please use safe tools, ladders and install practices. Measure twice cut once…
1) Identify desired location of the ceiling tile for the Trio Ceiling Mic to be installed. Use the Tile Support Brace
as a template. Measure, then cut a 5/8 to 3/4” hole into ceiling tile - be very accurate with cutting the hole.
Score the front of the tile to get a clean cut.
2) Install the included Tile Support Brace by aligning ceiling tile hole with openings on the bridge. There are
hanging holes along the folded up edges of the tile brace so that it can be tied to the building structure.
3) Remove top cover on the Ceiling Mic Array Interface Module.
4) Place the Ceiling Mic Interface Module on the installed Tile Support Brace with the feed-through coupler
extending through the hole in brace and ceiling tile.
5) Install the Microphone Array head by feeding drop cable through the 5/8” coupler and plug into the RJ-45
connector labeled IN FROM MIC on the interior of the Ceiling Interface Module. Make sure trim cover and
the 1.5” white plastic trim ring is slid over the MicPOD RJ-45 Jack prior to feeding drop cable through coupler.
Adjust hanging length of Mic Array Head by placing service loop into strain relief clamp. Lock relief clamp
once desired ceiling hanging height is achieved. Screw trim cover onto feed-through coupler until flush with
the 1.5” white plastic trim ring and the ceiling tile.
6) Route Cat-5’s RJ-45 connector originating from the TRIO MIC I/O through the conduit coupler on the end of
the Ceiling Interface Module. Connect the Cat-5 cable to the internal connector labeled OUT TO MIXER.
Re-attach the lid cover removed in step 3.
Cat-5
Cable
Tuck Cable into
Channel and
under Tabs