Vaddio WallVIEW PRO HD-1 - Manual (Page 4)

WallVIEW PRO HD1 Installation and User Guide 341-661 Rev. D Page 4 of 14
Wiring Diagram Example* for Interfacing with TANDBERG Video Switch:
Requires optional TANDBERG DB-9 to RJ-45 Adapter – Part # 998-1002-232
Daisy Chain Control Configuration:
The WallVIEW PRO HD1 has provisions for daisy chaining control signals when using an RS-232 controller
with only one (1) RS-232 output. Each EZIM has a RS-232 input and a RS-232 output (Figure 3).
Figure 5:
Daisy chain control configuration using two (2) WallVIEW PRO HD1 systems and a
single RS-232 output control device. See Appendix 1 for wiring and pin-out information.
RS-232 Out via Cat. 5
Cable RS-232 Out RS-232 Input RS-232 Input
Figure 4: Basic connectivity of the WallVIEW PRO HD1 with TANDBERG Video Switch. The WallVIEW HD1 connected to a
TANDBERG 6000 MXP codec and utilizes an Optional RJ-45 to DB-9 adapter for PTZ control between the HD1 and codec.
IR signals are fed from the HD1 camera, to the Quick-Connect rack mount unit to the TANDBERG codec via an IR probe (not
supplied) – see Step 7 for additional information. The Power, Video and Control Cat. 5 cables can be run up to 500 from the
Quick-Connect box to the EZ Interface Module, which connects to the camera. NOTE: See TANDBERG Step 9 for
additional information on IR Probe Wiring and compatible probes.
Vaddio/Sony Joystick
Part # 999-6605-000
EZIM
RS-232
Cat. 5 Cables Up to 500’
Quick-Connect
PRO HD Video
HD1 on Mount with EZIM mounted
under camera and inside camera mount
④
③
②
①
TANDBERG IR codes
sent through the camera,
EZIM and Quick-Connect
PRO to HDX Codec
Proprietary
LVDS Signal
IR Probe
TANDBERG
TVS
TANDBERG 6000 MXP
Vaddio HD Interface
Cable for WallVIEW HD1
DB-25M
Connector List
① DB-15HD (Y,P
B
,P
R
)
② RS-232 IN (8-Pin Min Din)
③ RS-232 OUT (8-Pin Mini Din)
④ POWER (EIAJ4)
* Optional TANDBERG
RJ-45 Adapter