Vaddio WallVIEW PRO HD-1 - Manual (Page 5)

WallVIEW PRO HD1 Installation and User Guide 341-661 Rev. D Page 5 of 14
MOUNTING INSTRUCTIONS
Step 1:
After determining the optimum location of the camera system, mark locations for the four screw holes and
cable pass-thru (vertical oval). Install the drywall mounts and cut the hole for the cable pass-thru. At this
point, do not install the Wall Mount.
Step 2:
Set the camera output resolution. The resolution of the camera can be set to HD (high definition) or SD
(standard-definition). The EVI-HD1 cannot output both HD and SD concurrently, so a choice must be made
with the rotary SYSTEM SELECT switch (Figure 5 and Table 1). Also, if an IR Remote is going to be used to
control the camera, chose the IR frequency with the IR SELECT switch
. NOTE: SD break-out cable sold
separately.
System Select
1080i/59.94 8 1080i/50
1 1080p/29.97 9 1080p/25
720p/59.94 A 720p/50
720p/29.97 B 720p/25
4 480i/59.94 (LB) C 576i/50 (LB)
5 480i/59.94 (CR) D 576i/50 (CR)
6 480i/59.94 (SQ) E 576i/50 (SQ)
7 F
Step 3:
Connect the 25-pin cable to the EZIM. Next, mount the EZIM and break out cable to the back of the wall
mount, using the two tapped screw holes (see Figure 6).
System Select
0 1080i/59.94 8 1080i/50
1 1080p/29.97 9 1080p/25
2 720p/59.94 A 720p/50
3 720p/29.97 B 720p/25
4
480i/59.94 (LB) C 576i/50 (LB)
5 480i/59.94 (CR) D 576i/50 (CR)
6 480i/59.94 (SQ) E 576i/50 (SQ)
7 F
Figure 6:
Thin Profile Wall Mount with oval cable feed-
through hole. The wall mount may be mounted
directly to a 2-gang wall box or to drywall with
wall anchors.
Figure 8:
25-pin connector mounted to
EZIM (left) and EZIM
mounted to the back of the
Wall Mount (right)
Figure 7:
Rear panel of EVI-HD1
Table 1:
System Select switch settings supports
both NTSC and PAL formats, LB = Letter
Box, CR = Cropped, SQ = Squeezed.
Note: See Sony Manual for switch setting
definitions.
System Select
Switch
IR Select
Switch
Note: If IR forwarding is to be used turn dip switch
#1 on the bottom of the camera to the ON position