Vaddio WallVIEW PRO HD-1 User Manual
Page 6
WallVIEW PRO HD1 Installation and User Guide 341-661 Rev. D Page 6 of 14
Step 4:
Place the wall mount, without the EZIM installed, against the drywall anchors or 2-gang wall box, making
sure to pull the Cat. 5 cables through the oval hole at the back of the mount. Finger-tighten the screws to the
mount and confirm that the base is level. Tighten the screws firmly. If the bracket is to be mounted on a 2-
gang wall box, use screws supplied with the electrical box.
Step 5:
Place the EZIM onto the wall mount and with the supplied screws, mount the EZIM to the Wall Mount (see
Figure 6, right photo). Connect the cables to the back of the HD1 PTZ camera, and then secure the camera
to the mount and using the ¼”-20 screw.
Step 6:
Connecting the Quick Connect PRO. The Quick Connect PRO is a 1-RU rack mount interface that breaks
out the signals from the Cat. 5 cables back to the standard connectors. The basic system connectivity is
illustrated in Figures 2 & 3.
Step 7:
Check all Cat. 5 cables for proper continuity in advance of final connection. Attach the Cat. 5 cables for
Power, Video and Control to the Quick-Connect PRO rack mount interface. Connect the BNC video output
connectors – either HD or SD – depending on where the SYSTEM SELECT rotary switch was set in Step 2.
Connect the PowerRite 36 VDC power supply to the Quick-Connect PRO power input.
Note: Plugging the POWER Cat. 5 Cable into the wrong RJ-45 may cause damage to the camera system and void the warranty.
Step 8:
The Quick-Connect PRO interface has an 8-position dip switch on the rear panel to allow the selection of IR
Forwarding Mode for Polycom® and TANDBERG® codecs. The following table defines the dip switch
settings:
DIP Switch Example
WallVIEW Universal PRO back panel
Description Dip Switch (Up = ON)
1
2
3
4
5
6
7
8
IR Forwarding through main camera for use with Polycom
HDX-9000 Series Codecs
•
2-wire signal & GND connection only to IR spring cage connector on the
back panel of the codec
*
*
*
*
*
*
UP
UP
IR Forwarding through main camera for use with Polycom
HDX-8000/7000 Series Codecs
•
Single wire from RJ-45 to DB-9 adapter to “SIG” pin on IR Port of the
back of the Quick-Connect PRO
*
*
*
*
*
*
DN
UP
IR Forwarding through main camera for use with TANDBERG
MXP (using the TANDBERG TVS) Codecs
•
Modulated IR signal from Quick-Connect PRO to IR probe attached to the
front panel IR window of the codec
o
Compatible IR Emitters
Xantech 282MRP
Xantech
283M
*
*
*
*
*
*
UP
DN
UP
DN