Westwood Design Monterey Convertible Crib - Manual (Page 6)

Required Hardware
8 x Barrel Nut (I)
8 x Allen Bolt, 3-1/8” Long (J)
8 x Nylon Washer (M)
Allen Wrench (R)
Crib Side (D)
Nylon Washer (M)
Allen Bolt (J)
Barrel Nut (I)
Crib Side (E)
Step 1
A. Position the stabilizer bars so that the four large holes face the inside of the
crib. The two smaller holes for the spring deck should be at the top.
B. Place a barrel nut (I) in the hole, with the slot aligned horizontally.
C. Place a washer (M) on the allen bolt (J), then put the bolt through the crib side
and thread it into the barrel nut.
D. Use the allen wrench to securely tighten the bolt.
E. Repeat with the remaining 7 holes.
Stabilizer Bar (H)
Spring deck mounting holes should be
toward the top