NaceCare Solutions DP620 - Manual (Page 14)

14
Brown horsehair brushes:
The polishing of smooth surfaces is carried out after having evenly distributed
a thin layer of liquid wax over the floor. Wait for the wax to dry completely
before polishing.
Set the register to the MU (Mop-Up) position towards the top. The RT register
must be set to the “Heavy Wash” or “Delicate Wash” positions, then move
the machine forwards and backwards in order to polish the floor.
Do not use the machine for spreading the wax.
(The horsehair brushes must not be used with water or detergents).
Compact “scotch-brite” brushes :
Only for fine polishing and endowing waxed and very smooth floors with a
mirror finish.
Tinex brushes:
Extremely abrasive for removing paint, plaster, incrustations of cement and
other products, even when dried hard on resistant industrial floors: gres,
porphyry, klinker, cotto, etc. (These brushes can normally be used with water
and detergents; due to their abrasive power they may damage the floor).
SPECIAL PROCEDURES
Waxing the floor with the “Lavaincera” system
Some floors are extremely suitable for being washed and treated with the
“Lavaincera” thanks to their specific characteristics, like those in cotto,
smooth tiles, klinker, marble, granite, industrial floors, roun raised rubber
floors, rubber, old pre-treated wax floors and many others.
Excellent results and a good “polished look” can be obtained with this solution,
as well as a thorough washing of the entire floor and an instantaneous recovery
of the dirt in a simple, fast and economical manner.
For this procedure it is possible to use the machine with the two normal grey
brushes that come with the machine.