NaceCare Solutions DP620 - Manual (Page 7)

7
Fig. 1
Fig. 2
à
Fig. 3
ASSEMBLING THE HANDLE
Insert the elbow of the handle into
the housing of the jointed elbow.
Tighten the two screws with the
screwdriver supplied and tighten
well. (fig. 1)
Assemble the handgrip if the handle by
pushing it through the connecting casing
and make sure to point the screws inwards
with the cable-holder facing towards the
bottom.
Screw up the three screws with the same
screwdriver supplied. (fig. 2).
The assembled handle must be as illustrated in the drawing
to the right.
Adjust the screw of the register located underneath the lever of the handgrip,
at the same time observing the positioning of the feelers that allow the liquid
to exit from the tanks. (fig. 3)