NaceCare Solutions RM1800F User Manual

Page 2

Advertising
background image

2

Overview

The FoamTec 1800 is a restroom care machine that sprays foaming chemical onto surfaces

that need cleaning. Next, the foam and the dirt are removed by rinsing the surfaces with

clean water. Then, with the same machine, you can also vacuum the liquid from hard floors.

The FoamTec has been designed for cleaning and sanitizing fixtures and other surfaces in

restrooms and shower areas in the education sector and in areas open to public, such as

train stations, airports, rest areas, swimming pools, fitness centres, saunas, hospitals, hotels

and so on. The FoamTec can be used in any other place where the foam + rinse + vacuum

system is convenient.

Safety instructions (read carefully)

Every electrical device must be used only for its particular function, respecting the

manufacturer’s instructions. Failure to follow the instructions could result in serious bodily

injury to the operator (electric shock, electrocution, etc.). Today, machines are produced

according to accident prevention regulations and qualified safety institutes approve them.

However, irresponsible use may put people in serious danger. Carefully read the following

points and be sure to understand everything before using the machine.

• Before connecting the machine’s plug to the electrical socket, check that the voltage available

is the same as indicated on the label of the machines.

Be sure that the electrical system is grounded and that it is supplied with a ground fault

interrupter. (GFI)

• Verify that the electrical plug complies with the wall outlet.
• Do not use adapters or multiple sockets without knowing the electrical input of each device

connected to the socket.

• If any electrical extension is used, check that it corresponds to the absorbed power of the

machine. It must be sealed against water.

• Take care of the cable. It is essential that it is protected from water, tearing and chemical

agents. Do not repair the cable if it is damaged replace it with a new one.

• Do not pull the cable to move the machine or to extract the plug from the socket. Pull out the

socket only when the machine is switched off.

• Do not handle the electrical plug with wet hands.
• Do not spray water near outlets. Do not use the machine to spray or to suck corrosive liquids

(acids or bases), explosive or flammable liquids (gasoline, kerosene, solvents, etc.) or dust.

• Do not use the machine in an explosive environment.
• Do not allow the machine to be used by children and persons unable to understand the danger

connected with using electrical power.

Advertising