NaceCare Solutions RM1800F - Manual (Page 8)

8
STEP E – VACUUMING THE FLOOR
After completing the above procedures you can vacuum the solution from the floor.
To vacuum the liquid, proceed as follows:
1. Connect the vacuum hose to the vacuum port at the rear of the machine.
2. Make sure the defoamer bottle is connected to the vacuum hose line.
3. Connect the hose to the wand
4. Switch the vacuum motor on using the vacuum 1 switch on the top panel.
5. Vacuum floor from the front or door to the rear, this will keep the hose clean and dry.
6. Vacuum grouted tile on a 45-degree angle for better pick up.
7. Return the hose to the machine and loop it back on its holders.
NOTE: After vacuuming the residual liquid, do not re-fill the clean water tank before
draining the recovery tank.
STEP F – BLOW DRY FIXTURES (OPTIONAL)
This optional step is used when the area cleaned is going to be in use immediately after the
above procedures are completed. Only the “touchables” need to be dried; faucets, flushers
and toilet seats.
Turn the vacuum switch on and connect the stretch blow hose to the outlet hole on the right
side of the machine. When drying toilet seats, work in a circular motion from the center out to
avoid splashing.
ATTENTION: You must spray a sufficient quantity of product to clean the surface, keeping
in mind that the foam that really works against dirt is just the foam adhering to the surface.
Any further layers of foam sprayed will not improve the result.
NOTE: The air compressor is controlled by a pressure switch. Once the compressor reaches
a certain pressure, it will shut itself off and only turn on once the air pressure drops below
that pressure.
NOTE: The compressor is provided with a safety thermal protection, which intervenes to
protect it from overheating. If the compressor stops suddenly, when the pressure or the air
has not yet reached its steady value, then it can be due to overheating. If this happens,
check that the voltage supplied to the machine corresponds to the value indicated on the