NaceCare Solutions ST50BT - Manual (Page 7)

7
MACHINE PREPARATION
INSTALLING THE BATTERY (BATTERY OPERATED MACHINE ONLY)
Figure 5
We recommend, in order to have good operating autonomy, installing a
12Vx140Ah/20h battery. Make sure that the battery is charged before installing.
WARNING: carefully follow the battery constructor or distributor’s
instructions for the maintenance, the first charge and the daily recharging.
Professionals must carry out all the installing and maintenance procedures.
Installation instructions:
• Turn push-button (d) to off.
Figure 6
• Open the machine cover
• Put the battery in its compartment.
• Connect the positive and negative connections as shown in the figure.
• Close the cover.
CONNECTING BATTERY CHARGER
Figure 7
Under the bonnet you find the connector where the battery charger connectors shall
be connected. The coupling connector is delivered in the bag together with this
instruction manual and it should be mounted on the battery charger cables, paying
attention to polarity.
BATTERY RECHARGING
To avoid permanent damage to the batteries, do not ever allow them to run down
completely and recharge them within few minutes after the battery indicator, figure 4,
(e) starts flashing.
WARNING: Do not ever allow batteries to run completely down, even when
the machine is not used. During recharging check the electrolyte level and add distilled
water, if necessary.
WARNING: Danger of gas exhalation and corrosive substances emission.
Fire danger: do not approach with flames.