NaceCare Solutions TTV678 - Manual (Page 10)

233890 05/11 (A03) 10
Machine Set Up
Setting the width adjustment
Filling the clean water tank
First push the side pod in (see fig.13), then pull the side pod adjustment lever
and set it to one of the three width-settings (see fig.13a) Repeat the
operation on both sides.
650mm 750mm 850mm
Fig.13
Fig.14 Fig.15 Fig.16
Fig.16a
Fig.13a
The TTV-678 is equipped with a large capacity 110 litre clean-water tank allowing, for large areas to be covered in
a single fill.
To fill the clean-water tank, lift the cover flap (fig.14) to expose the filler cap.
Unscrew the filler cap (fig.15) and fill the tank using a hose (fig.16) or preferred method.
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the filling process. If using a bucket or similar, ensure it is always clean and free from
debris.
Fill-level indicator
The water level in the clean water tank can be measured using the
scale on the rear of the machine (fig.16a).