Common kvm commands, Factory reset, Virtual loadmaster for kvm – KEMP KVM User Manual

Page 13: 2 common kvm commands, 3 factory reset

Advertising

Virtual LoadMaster for KVM

Installation guide

Figure 3-3: Nameserver IP addresses

4. Enter a space-separated list of nameserver IP addresses.

5. A message will appear asking to continue licensing via the WUI. Try to access the IP

address via a web browser. Ensure to enter https:// before the IP address.

6. Contact the local KEMP Customer Services Representative for further support if needed.

3.2

Common KVM Commands

The following list describes some commonly used KVM commands.



virsh console <NAME OF KVM / ID>

Connect to VM via local console



virsh shutdown <NAME OF KVM / ID>

Shutdown VM



virsh list

List running VMs



virsh destroy <NAME OF KVM / ID>

Delete a VM

Note that proper permissions are required to run these commands.

3.3

Factory Reset

If you perform a factory reset on your VLM, all configuration data, including the VLM’s IP address
is deleted. During the subsequent reboot the VLM attempts to obtain an IP address via DHCP. If
the VLM is on a different subnet to the DHCP server then an IP address will not be obtained and
the IP address is set to the default 192.168.1.101.

The VLM may not be accessible using this address. If this is the case then you must run through
the quick setup via the console as described in Section 3.1.

Advertising