Full Throttle Polaris 007-1031 - Manual

TM
INSTALLATION INSTRUCTIONS FOR
ATV’s
INSTALL AT YOUR OWN RISK!
PLEASE READ ATTACHED INSTRUCTIONS IN THEIR ENTIRETY .
A. Stainless Steel Adaptor Plate
B. Bullet Bolt
C. Nyloc Nut
D. Button Head Screw
E. Small Adaptor Bolt
F. Washer (2)
G. Crimp End
H.
Rubber Accordion Boot
I. Ferrell End
J.
Zip Ties (4)
K. Black Cable Housing
L. Stainless Steel Cable
M. Nylon Spacer
N.
Allen Wrench (1 Small, 1 large)
O. Goldfinger Lever w/ Safty Pin
attached
CAUTION: Improper assembly of this device may result in serious injury or even death, not to mention damage to your machine.
Before beginning, you must carefully read ALL INSTRUCTIONS, as well as attached DISCLAIMER INFORMATION. If you have
any questions call to speak with one of our Technical Advisors at (509) 927-7533. While installation is quite simple, it should
ONLY be performed by those possessing solid mechanical abilities
Part One: Installation of Left-Side Throttle Lever Perch (SEE PHOTO A)
OBJECTIVE: The goal for this section will be to position the throttle lever perch assembly as close as possible to the left side of
the brake or switch housing on the left side of handlebars. The lever should be hanging in the
straight down position. On many models the throttle lever perch will fit over the left side handle-
bar with no modifications to the grip.
1) Your perch has two smaller bolts on the top, remove both bolts with the small allen wrench
and remove the perch top.
2) Position perch over handlebar as close as possible to the left side of the brake reservoir/
switch housing assembly on the left side of handlebars. Then close the perch together with the
Goldfinger lever in the position of 6:00 (straight down). There is a nylon spacer provided if de-
sired application is on the handle bar rather then the grip.
3)Secure the perch by replacing the bolt(s). Be careful not to cross the threads.
CAUTION: In no case should your GOLDFINGER throttle lever be parallel to your brake lever!
A
Part Two: Installation of Right-Side Throttle Adapter Plate (SEE
PHOTO B)
OBJECTIVE: The goal of this section is to install the stainless steel adaptor plate to the
right side of the handle bars. As seen in photo B (adaptor plate is letter M in parts section
of instructions)
1)Take the adaptor bolt provided in kit and thread one washer on to it, then thread
through the open hole on the stainless steel adaptor plate, (The head of the bolt should
be on the opposite side of the side with the bullet bolt on it. Then thread another washer
onto the adaptor bolt.
Hollow cylinder
hole (screw adaptor
screw in here)
Throttle Block
O
K L
J
N
M
C
A
B
G
I
E D
F
H
B