j5 create JUD500 USB 3.0 Ultra Station - Manual (Page 7)

6
1. Start Device Driver Installation (please refer to your PC system OS installation in next section)
*Note: install driver completely before following steps.
2. Plug the Power Adapter to Port 1
3. Connect USB 3.0 Cable Micro-B connector to Port2 ,type A to host laptop
4. Connect HDMI or VGA Cable of Display device to Port 5 or 6
5. Connect Ethernet Cable to Port 9
6. Connect Audio Cable(audio out, audio in)to Port 7 & 8
7. Lay your laptop on the top of the j5 Ultra Station
8. Push the “j5” power button
9. USB HUB port 3,4,10 are now ready to use
10. Connect USB 2.0 Cable Micro-B connector to Port 11, and Type-A connector to the USB
port of the second computer. To Start the Wormhole Switch Function ,Please refer to the
Installation for Wormhole
INSTALLATION FOR WINDOWS
Device Driver Installation
This section illustrates the simple device driver installation guide for Windows 7 operating
system. When your computer is ready to use insert the Driver CD into CD-ROM drive. The setup
program should be launched automatically; if it doesn’t, go to “Computer,” click on your
optical drive, and manually run the setup CD. Double Click on “Setup.exe” to start.
※Make sure the USB cable is unplugged from your PC or Notebook before executing the
installation program.
1. The installation page will be launched. To
start click on “ Install the Latest Driver”. Please
make sure the network is available or press
“Install Driver” to start the installation 2. After pressing the installation option, the
InstallShield Wizard will launch, click Next>
to continue