Goulds Pumps 3393 - IOM - Manual (Page 102)

Maintenance
Radial Suction Configuration
First, complete the steps in "End and radial suction configuration common assembly
procedures" before completing the steps below.
1. Replace suction casing (100S) and align with shaft.
2. Install tie rods through the tie rod holes in the suction casing and secure them to the
discharge casing by threading them into the casing using the flats on the tie rods to screw
them into the discharge casing or by using the tie rod nuts (357F) and tie rod washers
(437A).
3. Install tie rod nuts (357F) and tie rod washers (437A) on tie rods and tighten to correct
torque values.
See Appendix A for correct torque values and Appendix D for correct torqueing sequence.
4. Install seal chamber studs (356Y) in radial suction casing.
5. Replace mechanical seal and gland as noted in instructions for assembly of mechanical
seal.
100 Model 3393 Installation, Operation, and Maintenance Manual