Goulds Pumps ANSI FAMILY IOM (ATEX Compliant) - Manual (Page 30)

6. Check and verify the dimensions again before the
grouting procedure begins.
7. A low slump standard concrete mix is suitable for
filling the Polyshield
® ANSI Combo in new
construction.
8. Seal around the outside bottom perimeter of the
Polyshield
® ANSI Combo with a fast setting
hydraulic cement. Two brand name hydraulic
cements are: Water Plug Hydraulic Cement
and Dam-It Non Shrink Hydraulic Cement
9. Pour the concrete mixture through the grout fill
port on the top of the Polyshield
® ANSI Combo
using a concrete vibrator to ensure proper flow of
the concrete. Do not over vibrate as excessive
vibrating leads to larger aggregate settling which
will result in a weak mix.
10. Pour the concrete to the bottom edge of the grout
fill port.
11. Remove any loose debris from around edges of
the grout fill port.
12. Seal grout fill port with grout port plug and
Polyshield
®
Seal Kit provided.
13. Install pump, motor, and attach lines.
TOOLS FOR INSTALLATION
•
Hammer drill with proper size bit
•
Worm gear saw with diamond blade(if required)
•
Rebar cutters (new installation)
•
Concrete mixer
•
Concrete vibrator
•
Lifting device (for placing Polyshield
®
Foundation)
•
Hand tools
•
Chipping hammer
•
Pressure washer or abrasive blast rig as
required
•
Epoxy adhesive (for setting rebar into concrete
slab – new installation)
•
Rebar tie wire
•
Fast set cement
Polyshield ® ANSI Combo Sealing Kit
Epoxy Novolac (EN) Instructions
Each Kit contains:
•
Polyshield
®
EN Resin
•
Polyshield
®
EN Hardener
•
Stir Sticks
•
LATEX Gloves
•
Instruction Sheet
•
MSDS Material Safety Data Sheet
Application Instructions:
The Polyshield ® EN Sealing Kit is intended for use in
(1) bonding the plug into the grout hole at the top of
the combo and (2) sealing and providing chemical
resistance barrier around the perimeter of pump pad.
1. All surfaces to be bonded should be thoroughly
cleaned and should be free of dust, oils and
contaminants. Sand surfaces to be bonded prior
to use.
2. Pour Polyshield ® EN Hardener into the
Polyshield
®
Resin can. Mix well with stir stick for
about two minutes.
3. Apply to properly prepared surface by stir stick or
putty knife.
4. Use MEK, Xylene solvents for cleaning tools and
equipment and for lightly brushing surface to
provide a smooth finish.
Safety Precautions
s
! WARNING
Resin and hardener components may be
irritating to the eyes and skin on contact.
Vapors may cause irritation of eyes and
respiratory tract. Area must be ventilated.
Wear protective clothing including gloves. For
details safety information, refer to the Material
Safety Data Sheets of these products.
Polyshield ® ANSI Combo Sealing Kit
Vinyl Ester (VE) Instructions
Each Kit contains:
•
Polyshield
®
VE Resin
•
Polyshield ® VE Hardeners #1
•
Stir Sticks
•
LATEX Gloves
•
Instruction Sheet
•
MSDS Material Safety Data Sheet
28
ANSIFAM IOM - 5/08