Rugged Ridge Standard Locking Console, Black Denim, 76-95 Jeep CJ & Wrangler - Manual (Page 5)

CAUTION: Take care not to cut or trip any wires/lines that might be
in the area.
4. Secure the Console to the floor of the vehicle using the (2) 14 X 1 ¾”
Sheet Metal Screws provided.
5. Remove the Consoles cup holder to expose the inner front section (Figure
3).
6. Drill one hole in the center and as far forward as possible through the
bottom of the Console and the floor of the vehicle using a 3/16” drill bit
(Figure 4).
7. Secure using (1) 14 X 1 ¾” Sheet Metal Screw provided.
NOTE: For the console to the floor support, you opt to install (2) 14 X 1
¾” Sheet Metal Screws instead of (1).
Figure 3 Figure 4
Ensure that all Screws are secure
Made in China