Rugged Ridge Offroad Jack Mounting Bracket, 07-14 Jeep Wrangler (JK) - Manual (Page 2)

11586.01
JK HI-LIFT JACK MOUNTING BRACKET
3. Install upper mounting plate into position by first removing the
upper left tailgate hinge bolt. Use (1) M8 bolt with (1) 25mm spacer and
(3) M8 washers to secure the upper mounting plate to the left hole of
the upper tailgate hinge. Do not fully tighten as this plate will have to
rotate behind the mounting bracket after it is installed. Next, remove
the upper right tailgate hinge bolt.
If no RR tire carrier is present, rotate the bracket installed in step 2 into
its vertical position and the upper mounting plate into its horizontal
position. Line up the holes in the plate and the bracket with the upper
right tailgate hinge hole. Tighten the bracket into place using the
remaining M8 hardware as shown. Also, fully tighten the bottom right
tailgate hinge bolt.
4. If installing Off Road Mounting Bracket with a RR tire carrier,
secure the mounting bracket to the lower mounting plate’s top two
holes using M10 hardware as shown. The upper mounting plate can
now be rotated into its horizontal position to line up with the mounting
bracket’s middle hole and the upper right tailgate hinge hole. Insert
the remaining M8 hardware and tighten. Go back and make sure all
bolts are tightened before inserting your Off Road Jack.
If installing Off Road Mounting Bracket without a RR tire carrier, install
the final M10 bolts into the bottom holes in the mounting bracket as
shown. Go back and make sure all bolts are tightened before inserting
your Off Road Jack.
Page 2 of 3