Rugged Ridge Offroad Jack Mounting Bracket, 07-14 Jeep Wrangler (JK) - Manual (Page 3)

11586.01
JK HI-LIFT JACK MOUNTING BRACKET
Page 3 of 3
5. You are now ready to install your Off Road Jack. Use the bottom
knob to clamp the base of the jack into position being sure that the
rear of the base is slid back under the tab in the mounting bracket.
Close the top swing arm making sure the rubber pads grip the jack’s
vertical beam.
Rugged Ridge Limited Warranty
Applies to Rugged Ridge Products by OMIX-ADA Inc.
Please find warranty card supplied with product for more information. Warranty card
should be filled out and returned to address listed below.
OMIX-ADA Inc.
460 Horizon Dr. Suite 400
Suwanee, Georgia 30024
UP
PASSENGER
SIDE TAILGATE HINGE DRILL PATTERN