Mittler Bros Machine & Tool 204-36 - Manual (Page 14)

- 14 -
#200-009 Depth Stop Installation Instructions
Purpose: Edge guide surface for flat or curved panels to assist in creating straight line bead
profiles.
#200-14NV Rotary
# 200-10NV) Rotary
#210-24, #200-36, #200-42
INSTRUCTIONS:
1. Insert aluminum “T” block into machine throat opening from the right hand side.
2. (Looking at machine from bead roll end with motor in back).
3. Install proper length bolt and flat strap from the left hand side.
a. NOTE: The aluminum “T” block can be located anywhere within the length of the machine
throat to correspond with desired straight line position for creating a bead profile in metal.
4. Install round rod into the aluminum “T” block. NOTE: Round rod will telescope through “T” block to
allow for fine-tuning desired location.
5. Tighten “T” handle to secure round rod and edge guide surfaces at desired location.
Requires a 3/8”x16-2 ¼” SHCS
Requires a 3/8”x16-1 ¾”” SHCS
Requires a 3/8”x16-1 ¾”” SHCS