Machine set up (cont.) – Mittler Bros Machine & Tool 204-36 User Manual
Page 6
- 6 -
MACHINE SET UP (cont.)
1. Remove shoulder bolt holding the aluminum handle to bottom of the bead depth adjuster.
2. Install aluminum handle on top of bead depth adjuster and secure using the shoulder bolt.
3. Remove the (2) 3/8-16 x 1” bolts and washers from the ends of the shafts.
4. Turn the bead depth adjuster counter-clockwise a 1 - 2 turns to allow clearance for rolls to slide
onto the shafts.
5.
Place the bead rolls on the shafts with the MB logo stamp facing toward the machine.
Either roll can be put on either shaft, but we usually recommend the male Bead Roll go
on the top.
Note: On 1-1/2” or 2” wide Bead Rolls, the socket head cap screw (SHCS) & washer
MUST be installed in the Bead Roll recessed cavity.
6.
Secure the rolls to the shafts with the SHCS & washers removed in step #7 and tighten
both SHCS.
7. Place power cord and variable speed foot pedal on floor.
8. Plug into 115 volt, 1 phase, 60 hertz power outlet.
9. Machine is now ready for use.
SHCS Bolts and
Washers to
Secure Rolls
MB Logo to
Machine
Variable Speed
Foot Pedal
115 Volt
Plug
Bead Depth Adjuster
Turn Counter-clockwise to Open