Aiwa XR-EC10 - Manual (Page 10)

10
En
RADIO OPERATIONS
Manual tuning
1 Press TUNER/BAND repeatedly to select a band.
The unit switches to the radio from any other function
and alternates between FM and AM.
2 Press f or g repeatedly to tune in a station.
"TUNE" is displayed when a station is tuned in.
"STEREO" is displayed for FM stereo reception.
To search for a station automatically (Auto search)
Hold down f or g.
The unit searches for a station and stops at reception.
To stop the search manually, press f or g.
•Auto search may not stop at stations with weak signals.
Preset tuning
Preset up to 32 of your favourite stations and tune them in
directly.
Presetting stations
1 Tune in the desired station.
2 Press SET to store the station.
The preset number, beginning from "1" appears on the
display.
3 Repeat steps 1 and 2 to preset other stations.
The next station will not be stored if a total of 32 preset
stations have already been stored. ("FULL" is displayed.)
•If power is interrupted for more than approximately 12 hours,
all settings stored in memory after purchase need to be reset.
Tuning in preset stations
1 Select the band.
2 Press PRESET (PRESET +,- on the remote
control) repeatedly.
With each press, the station with the succeeding (or
preceding) preset number is tuned in.
You can tune in the desired preset station directly by
pressing the numbered buttons on the remote control.
- To select preset number 11, press +10 and 1.
- To select preset number 15, press +10 and 5.
To clear a preset station
1 Tune in the station by preset tuning.
2 Press s, then press SET within 6 seconds.
Preset station numbers in the band which are higher than
the cleared number decrease by one.
PRESET
SET
TUNER/BAND
SHIFT
f , g SET
TUNER MODE
0–10, +10
s
POWER
PRESET + , -
TUNER/BAND
f , g
s
01_10_15_XREC10_UC_En 02.3.15, 7:11 PM 10