Silverline Multi-Head Garden System 25cc - Manual (Page 13)

12
GB
Trimmer Line Installation
Instructions
NOTE : Operating with trimmer line of uneven length will increase vibration.
Always ensure the line is wound evenly and trimmed to equal lengths from
the Eyelets (1).
1. Depress the tabs in the housing and twist the cover to release.
Remove the cover and bump button
2. Remove the spool and spring
3. Clean all components and inspect for damage. Replace any
damaged items
4. Check eyelets are in their correct position
WARNING : Never operate the trimmer without the Eyelets (1).
5. Thread the new line through the anchor in the spool until the line
lengths are equal. Do not exceed maximum capacity of spool
6. Holding the Spool (5) with the line clamp slots uppermost, wind
the line clockwise in the spool using a finger to keep the two lines
separate
7. Lock the two ends of the line in the line clamp slots
8. Place the Spring (4) over the Arbor Bolt (3)
9. With the line clamp slots facing downwards into the housing, thread
the ends of the line through the Eyelets (1) in the housing. Do not
allow the line to become caught under the spool
10. Place the Bump Button (6) in the centre of the spool
11. Replace the Cover (7) by aligning the tabs and then twisting so that
the tabs engage with the slots in the cover
12. Pull the line free from the line clamp slots
13. Check that a maximum 100 – 125mm of line extends equally from
each eyelet. Trim line as necessary
1) Eyelet (x2)
2) Housing
3) Arbor Bolt
4) Spring 5) Spool
6) Bump Button
7) Cover
1
2
3
4
5
6
7