BrandTech Scientific Dispensette III - Manual (Page 38)

2
3
3'
1
38
First Steps
Is everything in the package?
Confirm that your package includes:
Bottle-top dispenser Dispensette ® , discharge tube, telescoping filling tube, SafetyPrime ™ recirculation
valve and recirculation tube (optional), mounting tool, different bottle adapters, O-ring FKM (for autoclav-
ing), a performance certificate and this operating manual.
2.
Mounting the
SafetyPrime ™
recirculation valve
(optional)
3.
Mounting the
Discharge tube
Wear protective clothing, eye protection and gloves! Follow all safety
instructions and observe limitations of use and operating limitations
(page 32-34).
Nominal volume, ml Adapters
bottle thread, PP Filling tube
Length, mm
0,5 24-25, 28/ S 28, 32-33, 38 mm 125-240
1, 2, 5, 10 28/ S 28, 32-33, 38 mm 125-240
25, 50, 100 32-33, 38 mm 170-330
Warning:
Assembly
Push the SafetyPrime ™ recirculation
valve approx. 2 mm into the discharge
tube and firmly finger-tighten the locking
nut (Fig. 2). Check the SafetyPrime
™
recirculation valve for a tight fit.
Push the discharge tube (optional with
SafetyPrime
™ recirculation valve, Fig. 3')
approx. 2 mm into the valve block and
and firmly finger-tighten the locking nut
(Fig. 3). Check the discharge tube for a
tight fit.
Before mounting the SafetyPrime ™ recir-
culation valve or the discharge tue make
sure that the sealing washer is inserted.
1.
Check sealing
washer(s)
Recirculation valve and discharge tube
must correspond to the model. Pay
attention to the color code. On the next
day firmly tighten up the locking nut.
Note: